Atmel MCU Technical Support Center

English | Chinese 中文

Products||||||

Atmel MCU Technical Support Center >

Frequently Asked Questions

[View the 10 most read entries for this topic]

Top\

English\

Name	Description
SAM3S Software Package Examples built for internal SRAM do not compile under IAR EWARM 5.41.X	SAM3S Software Package Examples built for internal SRAM do no...
Linux vs. Software Package Cross Toolchains	Linux vs. Software Package Cross Toolchains
Nandflash compatibility with SAMBA GUI	What are the parameters to check when using a nandflash with ...
SAM-BA JTAG mode: Hardware and Software Constraints	SAM-BA JTAG mode Hardware and Software Constraints
SAM-BA 2.6 could not program SAM7SE256 internal flash	SAM-BA V2.6 could not program the ...
I can't connect to SAM-BA with my AT91SAM9G20-EK through USB	I can't connect to SAM-BA with my AT91SAM9G20-EK thr...
I can't initialize or program the dataflash on an AT91SAM9G20-EK with SAMBA v2.8	You are observing one of the following scenarios: ...
Does our AT91SAM9 Boot ROM support boot from a High Capacity SDCard or SDHC?	Does our AT91SAM...
AT91SAM9XE512 support for SAM-BA 2.8 (AT91ISP 1.12)	I can't succeed in connecting with SAM-BA v...
Why is my AT91 device recognized as a "GPS Camera Detector" once connected to a USB port on my computer?	...
Supporting .NET Micro Framework	Are AT91SAM products integrated within .NET Micro Framework P...
Is the latest Micron MT29 NandFlash family (RevAAD) supported by SAM-BA?	Is the latest Micron MT29 NandFlash family (RevAAD) ...
My IAR Binary File Size is higher than expected (Software Package v1.4 Examples under IAR 5.x)	I use IAR toolchain v5.x. ...
USB VBUS detection (USBCNX signal) & SAM-BA Boot	Does the Boot RO...
SAM-BA and SAM-PROG Support in Bypass Mode	What are the possible solutions if I want to use SAM-BA or SAM-PROG in...
I can't initialize twice the dataflash on an AT91SAM9263-EK board with SAM-BA v2.7	On the SAM9263-EK board, If I execute several times the Enable Datafla...
AT91SAM7XC support for SAM-BA 2.7 (AT91ISP 1.11)	I can't succeed in connecting with SAM-BA v2.7 any AT91SAM7XC microcon...
SAM-BA via DBGU connection is not working correctly	SAM-BA via DBGU connection is not working correctly
Wide selection of Fn parameters for Atmel's PLL Calculation tool	Atmel provides a PLL Loop filter tool but what do I need to s...
SAM-BA v2.6 and NandFlash bad block management	SAM-BA v2.6 finds a lot of bad blocks when erasing or programming the ...
Writing and Erasing the AT91SAM7S Embedded Flash	Why can't I write or erase the AT91SAM7S embedded Flash?
Upgrading an AT91SAM7S64 to an AT91SAM7S256 under EWARM IAR tool	I want to upgrade my AT91SAM7S64 application to AT91SAM7S256. What do ...
AT91 Flash Memory Uploader	Where can I find the source code of the Flash Memory Uploader (FMU)?
Flash/ROM Startup Sequence Debugging	I want to debug my application stored in Flash/ROM memory from the res...
AT91RM9200 Linux Ressources	Where can I find ressources around Linux for the AT91RM9200?
U-Boot Binary Files	I have erased the flash content on the AT91RM9200DK where can I find t...
Does the AT91 software library compatible with Multi 2000 V3.X ?	Does the AT91 software library compatible with Multi 2000 V3.X ?
Nexgen TCP/IP Stack	Nexgen - 10 or 100 TCP/IP stack? IP or MAC Address ID ?
Software Bit Banged SPI Maximum Speed	If using the AT91M40800 with software bit-banged SPI, what is the maxi...
AT91SAM9263-EK SAM-BA connection problems	I can't connect to SAM-BA (or SAM-PROG) with my AT91SAM9263-E...
How to Program the AT91SAM7A3 with SAM-PROG and SAM-BA ?	How to Program the AT91SAM7A3 with SAM-PROG and SAM-BA ?